CPC ROC Plate Carrier Gen.4 | Templars Gear

Made of high quality laser-cut Cordura 500 laminate with ROC (Rapid Open Connector) buckles. Ballistic plates are mounted in two Velcro-fastened pockets. The whole surface of the vest has laser cut slots, which allow any desired configuration of pouches. Set also includes redesigned, Velcro-padded shoulder pads that allow for even distribution of the weight of the whole vest. The skeletal structure ensures excellent ventilation during use.  In addition, it is possible to install the side ballistic shields by rolling them in adapted pockets. 

Back of the vest is adapted to fasten additional panels with zip fasteners.

The internal part of Plate Carrier has special foam spacers that are designed to improve air circulation and comfort of use at full load.

On the front panel there is an elongated piece of turnip designed for patches or infrared identifiers.

On both sides of the front panel there are also adjustable loops for guiding the radio wires or the hydration system tube.

In the bottom section there is a wide Cummerbund belt, which consists of two layers of laminate with additional stiffeners. This ensures adequate rigidity of the structure even at high loads.

Adapted to carry SAPI / ESAPI ballistic plates with a maximum size of 24 x 32 cm